Delta-Q Technologies Corp.

How do I use the CAN bus on the charger?

By default, Delta-Q chargers with CAN bus are set to the settings below.  However, OEM-specific chargers may have this customized:

 

Protocol:   CANopen

Bus speed:  125kbps

Charger Node ID:  10

Battery Node ID:  1

PDO map:  CiA 418/419 default

 

In order to communicate with these chargers knowledge of CANopen CiA 301, and Device Profiles 418 and 419 are necessary.  These standards can be obtained from https://www.can-cia.org/. Delta-Q only supports CAN use by OEMs.  Other use of CAN may void charger warranty - check with your distributor.

 

J1939 protocol is also supported by Delta-Q but strictly for OEMs only due to the customization required.

Was this article helpful?
0 out of 1 found this helpful
Have more questions? Submit a request

Comments

Article is closed for comments.